These kits are built around the Fleck 9100 valve heads. The kit includes the valve heads, yokes, vessels, quality food grade softener resin, brine tank and all interal parts.
Fleck 9100 Valve
Fiber-reinforced polymer valve body for superior strength and durability, non-corrosive, and UV resistant
Continuous service flow rate of 20.1 GPM with a backwash of 8.5 GPM
Backwash capability accommodates softener tanks up to 16"
Fully adjustable 5-cycle control for efficient and reliable water treatment system
Time-tested, hydraulically-balanced piston for service and regeneration
Rugged-built electromechanical timer designed with heavy duty 3/8" wide plastic gears
Salt and water savings by using 100% capacity of the tank in service before switching to the second tank
Regenerates immediately when needed for continuous soft water
Regenerates with soft water keeping system clean for optimum operating efficiency and minimum maintenance
General Conditions for Installation
Connections Inlet & Outlet: 1" BSPF Drain Connection*: 1/2" hose barb Electrical rating: 230-24V / 50 Hz Power Rating: 8 watts Minimum inlet pressure: 2 Bar Maximum inlet pressure: 7 Bar Vacuum: Not permitted Average Pressure Loss**: 1 Bar Maximum water Temperature: 43°C
*Open drain required **It is recommended that a 20 micron pre-cartridge filter be installed prior to the inlet of the water softener
Regeneration will take immediately after reaching the set capacity
The interval between regenerations should not be more than 4 days, this is to prevent bacteria growth. Regenerations should be more than 8 hours apart.